Sony WH-RF400

Sony WH-RF400 priručnik

  • Wireless Stereo
    Headphone System
    ©2018 Sony Corporation Printed in Vietnam
    Operating Instructions
    Stereo mini plug
    Stereo mini cable
    Headphone jack
    (Stereo mini jack)
    TV, Digital music player, etc.
    To reduce the risk of fire or electric shock, do not
    expose this apparatus to rain or moisture.
    To reduce the risk of fire or electric shock, do not expose
    this apparatus to dripping or splashing, and do not place
    objects filled with liquids, such as vases, on the apparatus.
    Do not expose the batteries (battery pack or batteries
    installed) to excessive heat such as sunshine, fire or the
    like for a long time.
    To avoid electrical shock, do not open the cabinet. Refer
    servicing to qualified personnel only.
    Do not install the appliance in a confined space, such as a
    bookcase or built-in cabinet.
    The AC Adaptor is not disconnected from the mains as
    long as it is connected to the AC outlet, even if the unit
    itself has been turned off.
    As the main plug of AC power adaptor is used to
    disconnect the AC power adaptor from the mains, connect
    it to an easily accessible AC outlet. Should you notice an
    abnormality in it, disconnect it from the AC outlet
    Excessive sound pressure from earphones and
    headphones can cause hearing loss.
    The nameplate of transmitter is located on the bottom
    The nameplate of the headphones is located on the back
    side of the slider.
    You are cautioned that any changes or modifications not
    expressly approved in this manual could void your
    authority to operate this equipment.
    If you have any questions about this product:
    Contact: Sony Customer Information Service Center at
    Write: Sony Customer Information Service Center 12451
    Gateway Blvd., Fort Myers, FL 33913
    Declaration of Conformity
    Trade Name:SONY
    Model No.:WH-RF400R
    Responsible Party:Sony Electronics Inc.
    Address:16535 Via Esprillo, San Diego, CA 92127 U.S.A
    Telephone Number:858-942-2230
    This device complies with Part 15 of the FCC Rules.
    Operation is subject to the following two conditions: (1)
    this device may not cause harmful interference, and (2)
    this device must accept any interference received,
    including interference that may cause undesired
    This equipment has been tested and found to comply with
    the limits for a Class B digital device, pursuant to Part 15 of
    the FCC Rules. These limits are designed to provide
    reasonable protection against harmful interference in a
    residential installation. This equipment generates, uses
    and can radiate radio frequency energy and, if not
    installed and used in accordance with the instructions,
    may cause harmful interference to radio communications.
    However, there is no guarantee that interference will not
    occur in a particular installation. If this equipment does
    cause harmful interference to radio or television reception,
    which can be determined by turning the equipment off
    and on, the user is encouraged to try to correct the
    interference by one or more of the following measures:
    Reorient or relocate the receiving antenna.
    Increase the separation between the equipment and
    Connect the equipment into an outlet on a circuit
    different from that to which the receiver is connected.
    Consult the dealer or an experienced radio/ TV
    technician for help.
    For the customers in Canada
    This device complies with Industry Canada’s licence-
    exempt RSSs. Operation is subject to the following two
    (1)This device may not cause interference; and
    (2)This device must accept any interference, including
    interference that may cause undesired operation of the
    For the customers in the USA and
    Rechargeable batteries are recyclable.
    You can help preserve our environment by returning your
    used rechargeable batteries to the collection and recycling
    location nearest you.
    For more information regarding recycling of rechargeable
    batteries, visit
    Caution: Do not handle damaged or leaking rechargeable
    Note on static electricity
    Static electricity accumulated in the body may cause
    mild tingling in your ears. To reduce the effect, wear
    clothes made from natural materials, which suppress
    the generation of static electricity.
    This product has magnets which may interfere with
    pacemakers, defibrillators and programmable shunt
    valves or other medical devices. Do not put this product
    close to these medical devices and the person who use
    any of these medical devices. Consult your doctor before
    using this product, if you have any concerns.
    How to use
    Connect the AC adaptor. Charge the headphones.
    (Red) (Off)
    Complete when indicator
    turns off.
    Check the CHARGE/
    RED indicator lights
    up red.
    Connect the A/V component, following hookup or below.
    Using the headphone jack of the A/V component
    To AC
    AC adaptor
    Adjust the volume.
    After use
    Turn off the power of the headphones.
    About sending RF signals
    The transmitter starts sending RF signals
    automatically when it detects an audio signal from
    the connected component. Note that;
    Noise may occur depending on the transmitter
    position and room conditions. It is recommended
    to place the transmitter in a location that
    produces the clearest sound.
    If the transmitter is placed on a metallic table,
    you may hear noise, or the reception range may
    decrease. Do not place on a metallic table.
    If no signal or low signal is
    input for about 4 minutes
    When no signal is input for about 4 minutes, the
    transmitter turns off automatically*. The POWER
    indicator of the transmitter blinks for 4 minites,
    then turns off. The transmitter restarts after
    receiving an audio signal again.
    The transmitter may also turn off if low signal is
    input for about 4 minutes. In this case, raise the
    volume of the connected A/V component within
    the range where the sound is not distorted, then
    lower the volume of the headphones.
    * If signal noise is output from the connected A/V
    component, the transmitter may not turn off,
    even when no audio signal is input.
    Start playback of the A/V component.Wear the headphones.
    Before listening
    To reduce the risk of hearing damage, first lower the volume.
    Tactile dot
    Up Down
    Tactile dot
    Using the audio out (L/R) jacks of the A/V component
    If the sound is distorted by connecting the transmitter to the A/V component’s audio out (L/R) jacks, reconnect the transmitter to the headphone jack.
    If the transmitter detects no signal or no sound, check the connection of the connected A/V components, then check the audio setting of the connected A/V components.
    Charging is possible regardless of the direction of the headphones.
    Insert the supplied rechargeable battery BP-HP800-11 into the left housing of the headphones.
    Observe the correct polarity when installing battery.
    Rechargeable nickel-metal hydride
    battery BP-HP800-11 (supplied)
    Insert the
    end first.
    Checking the included
    RF stereo transmitter
    TMR-RF400 (1)
    AC adaptor (1)
    Plug adaptor (stereo mini
    plug phono plugs) (1)
    Wireless stereo
    headphones WH-RF400R
    Stereo mini cable (stereo
    mini plug), 1.5 m (1)
    Rechargeable nickel-metal
    hydride battery BP-
    HP800-11 (1)
    Thank you for purchasing the Sony WH-RF400 Wireless
    Stereo Headphone System. Before operating the unit,
    please read this manual thoroughly and retain it for future
    Some features are:
    Wireless system that allows you to listen to a program
    free the restriction of a cable
    Up to 45 meters (150 feet) reception range*
    High fidelity sound reproduction
    New mode “VOICE” for clear hearing of personal voice
    Noise reduction system to reproduce a clear sound with
    minimum transmission noise
    Comfortable fit
    Smooth and Comfortable Earpads
    Long playback time (maximum 20 hours)
    Easy recharging function with secure charging
    Rechargeable Battery
    Automatic tuning on headphones for optimum signal
    3 transmission channels available
    Volume control function and sound effect function on
    the headphones
    * Transmission distance varies depending on conditions of
    L (white)
    R (red)
    Stereo mini plug
    Audio out
    (L/R) jacks
    Stereo system, Blu-ray Disc player, DVD player, TV*, etc.
    * In case of no headphone jack.
    Stereo mini cable Plug adaptor (stereo
    mini plug phono plugs)
    2 3
    5 6
Sony WH-RF400

Trebate pomoć?

Broj pitanja: 0

Imate li pitanja u vezi s proizvodom WH-RF400 trgovačke marke Sony ili vam treba pomoć? Ovdje postavite svoje pitanje. Navedite jasan i sveobuhvatan opis problema i vašeg pitanja. Što više pojedinosti navedete za svoje pitanje i pitanje, lakše je drugim vlasnicima proizvoda WH-RF400 trgovačke marke Sony pravilno odgovoriti na vaše pitanje.

Ovdje besplatno pogledajte priručnik za proizvod WH-RF400 trgovačke marke Sony. Ovaj je priručnik pod kategorijom , a ocijenio ga je sljedeći broj osoba: 1 prosječnom ocjenom od 7.5. Ovaj je priručnik dostupan na sljedećim jezicima: Engleski. Imate li pitanja u vezi s proizvodom WH-RF400 trgovačke marke Sony ili vam treba pomoć? Ovdje postavite svoje pitanje

Značajke proizvoda WH-RF400 trgovačke marke Sony

Brend Sony
Model WH-RF400
Proizvod Slušalice
Jezik Engleski
Vrsta datoteke PDF